summaryrefslogtreecommitdiff
path: root/keyboards/wilba_tech/zeal60
diff options
context:
space:
mode:
Diffstat (limited to 'keyboards/wilba_tech/zeal60')
-rw-r--r--keyboards/wilba_tech/zeal60/rules.mk46
1 files changed, 8 insertions, 38 deletions
diff --git a/keyboards/wilba_tech/zeal60/rules.mk b/keyboards/wilba_tech/zeal60/rules.mk
index 5d20659f83..b8d63050c6 100644
--- a/keyboards/wilba_tech/zeal60/rules.mk
+++ b/keyboards/wilba_tech/zeal60/rules.mk
@@ -1,5 +1,3 @@
-
-
# project specific files
SRC = keyboards/wilba_tech/wt_main.c \
keyboards/wilba_tech/wt_rgb_backlight.c \
@@ -10,42 +8,14 @@ SRC = keyboards/wilba_tech/wt_main.c \
# MCU name
MCU = atmega32u4
-# Processor frequency.
-# This will define a symbol, F_CPU, in all source code files equal to the
-# processor frequency in Hz. You can then use this symbol in your source code to
-# calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-# automatically to create a 32-bit value in your source code.
-#
-# This will be an integer division of F_USB below, as it is sourced by
-# F_USB after it has run through any CPU prescalers. Note that this value
-# does not *change* the processor frequency - it should merely be updated to
-# reflect the processor speed set externally so that the code can use accurate
-# software delays.
-F_CPU = 16000000
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
-ARCH = AVR8
-
-# Input clock frequency.
-# This will define a symbol, F_USB, in all source code files equal to the
-# input clock frequency (before any prescaling is performed) in Hz. This value may
-# differ from F_CPU if prescaling is used on the latter, and is required as the
-# raw input clock is fed directly to the PLL sections of the AVR for high speed
-# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-# at the end, this will be done automatically to create a 32-bit value in your
-# source code.
-#
-# If no clock division is performed on the input clock inside the AVR (via the
-# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
-F_USB = $(F_CPU)
-
-# Interrupt driven control endpoint task(+60)
-OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
-
-# Boot Section
+# Bootloader selection
+# Teensy halfkay
+# Pro Micro caterina
+# Atmel DFU atmel-dfu
+# LUFA DFU lufa-dfu
+# QMK DFU qmk-dfu
+# ATmega32A bootloadHID
+# ATmega328P USBasp
BOOTLOADER = atmel-dfu
# Do not put the microcontroller into power saving mode