Add some defaults for ATmega32A to mcu_selection.mk (#6253)

* Add some defaults for ATmega32A to mcu_selection.mk

* Remove boilerplate from templates

* Relax INTERRUPT_CONTROL_ENDPOINT and PROGRAM_CMD

* Apply suggestions from code review

Co-Authored-By: Drashna Jaelre <drashna@live.com>

1 files changed, 0 insertions, 36 deletions

diff --git a/quantum/template/avr/rules.mk b/quantum/template/avr/rules.mk
index 133c9e363b..50deba92cf 100644
--- a/quantum/template/avr/rules.mk
+++ b/quantum/template/avr/rules.mk
@@ -1,42 +1,6 @@
 # MCU name
 MCU = atmega32u4
 
-# Processor frequency.
-#     This will define a symbol, F_CPU, in all source code files equal to the
-#     processor frequency in Hz. You can then use this symbol in your source code to
-#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-#     automatically to create a 32-bit value in your source code.
-#
-#     This will be an integer division of F_USB below, as it is sourced by
-#     F_USB after it has run through any CPU prescalers. Note that this value
-#     does not *change* the processor frequency - it should merely be updated to
-#     reflect the processor speed set externally so that the code can use accurate
-#     software delays.
-F_CPU = 16000000
-
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
-ARCH = AVR8
-
-# Input clock frequency.
-#     This will define a symbol, F_USB, in all source code files equal to the
-#     input clock frequency (before any prescaling is performed) in Hz. This value may
-#     differ from F_CPU if prescaling is used on the latter, and is required as the
-#     raw input clock is fed directly to the PLL sections of the AVR for high speed
-#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-#     at the end, this will be done automatically to create a 32-bit value in your
-#     source code.
-#
-#     If no clock division is performed on the input clock inside the AVR (via the
-#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
-F_USB = $(F_CPU)
-
-# Interrupt driven control endpoint task(+60)
-OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
-
 
 # Bootloader selection
 #   Teensy       halfkay