diff options
Diffstat (limited to 'keyboards/handwired/reddot/rules.mk')
| -rwxr-xr-x | keyboards/handwired/reddot/rules.mk | 53 |
1 files changed, 10 insertions, 43 deletions
diff --git a/keyboards/handwired/reddot/rules.mk b/keyboards/handwired/reddot/rules.mk index 8afe6fc63e..4400decaac 100755 --- a/keyboards/handwired/reddot/rules.mk +++ b/keyboards/handwired/reddot/rules.mk @@ -1,44 +1,14 @@ # MCU name MCU = atmega32u4 -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - -# for avr upload -USB = /dev/cu.usbmodem1421 -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Bootloader -# This definition is optional, and if your keyboard supports multiple bootloaders of -# different sizes, comment this out, and the correct address will be loaded -# automatically (+60). See bootloader.mk for all options. +# Bootloader selection +# Teensy halfkay +# Pro Micro caterina +# Atmel DFU atmel-dfu +# LUFA DFU lufa-dfu +# QMK DFU qmk-dfu +# ATmega32A bootloadHID +# ATmega328P USBasp ifdef TEENSY2 BOOTLOADER = halfkay OPT_DEFS += -DATREUS_TEENSY2 @@ -50,11 +20,6 @@ else avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB) endif -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT - - - # Build Options # change yes to no to disable # @@ -76,3 +41,5 @@ AUDIO_ENABLE = no # Audio output on port C6 # upload: build # $(ATREUS_UPLOAD_COMMAND) +# for avr upload +USB = /dev/cu.usbmodem1421 |