From 088888937a805c29304753a1f211845744d249e8 Mon Sep 17 00:00:00 2001 From: Takeshi ISHII <2170248+mtei@users.noreply.github.com> Date: Mon, 7 Sep 2020 13:15:55 +0900 Subject: Replace figures in docs/feature_split_keyboard.md (#10242) * Replace figures in feature_split_keyboard.md * fig update * Update docs/feature_split_keyboard.md Co-authored-by: Ryan Co-authored-by: Ryan --- docs/feature_split_keyboard.md | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-) (limited to 'docs/feature_split_keyboard.md') diff --git a/docs/feature_split_keyboard.md b/docs/feature_split_keyboard.md index ce470b9964..f054f365b6 100644 --- a/docs/feature_split_keyboard.md +++ b/docs/feature_split_keyboard.md @@ -48,11 +48,12 @@ However, USB cables, SATA cables, and even just 4 wires have been known to be us ### Serial Wiring -The 3 wires of the TRS/TRRS cable need to connect GND, VCC, and D0 (aka PDO or pin 3) between the two Pro Micros. +The 3 wires of the TRS/TRRS cable need to connect GND, VCC, and D0/D1/D2/D3 (aka PD0/PD1/PD2/PD3) between the two Pro Micros. ?> Note that the pin used here is actually set by `SOFT_SERIAL_PIN` below. -![serial wiring](https://i.imgur.com/C3D1GAQ.png) +sk-pd0-connection-mono +sk-pd2-connection-mono ### I2C Wiring @@ -60,7 +61,7 @@ The 4 wires of the TRRS cable need to connect GND, VCC, and SCL and SDA (aka PD0 The pull-up resistors may be placed on either half. If you wish to use the halves independently, it is also possible to use 4 resistors and have the pull-ups in both halves. -![I2C wiring](https://i.imgur.com/Hbzhc6E.png) +sk-i2c-connection-mono ## Firmware Configuration -- cgit v1.2.3